This unique multi-use product features two preset tungsten carbide cutting heads that allows you to quickly sharpen your broadhead. Plus, it comes with a wrench that is built into the handle that lets you easily remove your three, four, or five bladed broadhead safely and quickly. As an added bonus, you can use it to sharpen your knife. The BHS is packaged in a clamshell. Instructions for sharpening broadheads: Always keep fingers inside the protective hand guard while sharpening or injury could occur. Secure your broadhead so that it doesn't move. Then place the "V" groove that is created by the two tungsten carbide cutting heads over your broadhead blade. Some broadheads may need to be disassembled in order to sharpen the entire length of the blade. Hold the sharpener at a 90-degree angle to the broadhead blade and with light pressure pull the cutting heads down the blade until sharp. Three of four strokes is all it will take per blade. Repeat these steps on each blade. Instructions for broadhead wrench: Do not put your fingers inside the hand guard when removing your broadhead or injury could occur. Keep fingers on the outside of sharpener handle when loosening or tightening your broadhead. When using the wrench, select the proper slot that fits your broadhead. Slide broadhead into slot until snug and then loosen or tighten by rotating the handle. Do not over-tighten or injury could occur. Broadhead Sharpener BHS$5.95 Need more information? Please feel free to contact us at 1-800-592-6940 - Ask for Extension 547 or Internet Sales.